Tech Note 1026 Detail

SPARK SLS Screen Calibration

Affected Products:

PS-2008 SPARK Science Learning System

Problem/Symptom:
How do I calibrate the screen on the SPARK SLS?

PASCO Solution:
  1. Hold down both buttons on the front of the SPARK SLS.
  2. Tap on the center of the screen three times.
  3. Release both buttons on the front of the SPARK SLS.
  4. Follow the directions on the screen. (For a precise calibration, use a sharp soft pointing device such as your fingernail when clicking in the green boxes.)

Please see the following video that shows this process:

If this technique is not successful, please try the following steps:

  1. Turn off the SPARK SLS by holding down the power button.
  2. Hold down both buttons on the front of the SPARK SLS.
  3. While holding the buttons, turn on the SPARK SLS.
  4. When booting is complete follow the directions on the screen. (For a precise calibration, use a sharp soft pointing device such as your fingernail when clicking in the green boxes.)

Creation Date: 07/30/2009
Last Modified: 02/6/2015
Mod Summary: