1. Connect the 500 Interface to the serial port of the computer.
   
   
2. Plug the Force Sensor into analog channel A and the Motion Sensor into analog channel B.
   
   
3. Place dynamics track on a level horizontal surface. Attach the Super Pulley at one end and the Motion Sensor on the other end (see photo below).
   
   
   
   Note: PASPORT sensors are used for experiment setup purposes only and are not compatible with the 500 Interface.
   
   
4. Attach approximately 100 cm of string to the hook on the Force Sensor. Secure the mass hanger on the other end of the string by wrapping the string through the pinch slot on the hanger.
   
   
5. Attach the Force Sensor to the PAScar or Dynamics Cart and place the string over the pulley at the end of the track (see photo below). Place a small amount of mass on the mass hanger (20<m<50).
   
   
   Note: PASPORT sensors are used for experiment setup purposes only and are not compatible with the 500 Interface.
   

To download the Impulsivity DataStudio file, click on a Windows (Zip file) or Macintosh (Stuffit file).

You are now ready to begin collecting data.